Quarter-Turn Receptacle, Size 6, Clip-on, Steel, Zinc Immersion Coating

During the locking phase, as the nut continues to tighten, the reed continues to be subjected to greater compressive forces, producing greater elastic deformation. This elastic deformation causes an increase in friction between the nut and the bolt, which increases the tightening force of the connection. In this way, the reed nut provides high resistance to loosening and maintains the stability of the connection in vibrating environments.
The advantages of the reed nut are simple structure, easy installation, reusable, and good loosening resistance. It is widely used in automobiles, mechanical equipment, aerospace and other fields to ensure the reliability and safety of the connection.
In addition to reed nuts, there are some other types of nuts that can also provide preload and anti-loosening functions. For example, lock nuts prevent loosening by adding lock washers or embedded washers to the bottom of the nut to increase friction. Alternatively, elastic washer nuts provide preload and anti-loosening by incorporating an elastic washer between the nut and the bolt.    

Dacromet is a new surface treatment technology, compared with the conservative plating process, Dacromet is a "green plating". Its disadvantages have the following aspects:
1. Super corrosion resistance: the thinness of the Dacroc1 film layer is only 4-8μm, but its anti-rust effect is
Chrome-free dacromet
It is 7-10 times more than conservative galvanizing, hot dip galvanizing, or coating method. Black rust has been found in the scale parts and pipe parts treated with the dacromet process after a salt spray resistance test for more than 1200h.
2. No hydrogen firmness: The treatment process of Dacromet determines that Dacromet does not have hydrogen firmness, so Dacromet is very consistent with the coating of stressed parts.
3. Lower heat resistance: Dacromet may resist lower temperature corrosion, and the heat resistance temperature can reach more than 300℃. The conservative galvanizing process, when the temperature reaches 100 ° C, has been reported.
4. Separation and recoating instinct is good: Dacromet coating has a good separation force with the metal substrate and has a warm adhesion with the rest of the additional coating, the whole part after treatment is easy to spray coloring, and the separation force of the organic coating even exceeds the phosphating film.
5. Good permeability: Due to the effect of electrostatic shielding, the deep hole, slit, inner wall, and other parts of the workpiece are easy to be zinc plated, so the above parts of the workpiece can not be taken care of with the main points of electroplating. Dacromet may be added to those parts of the workpiece to produce a dead dacromet coating.
Organic solvent degreasing - flat - spraying - baking - twice spraying - baking - drying