Stainless steel Slotted thin wall self-tapping inserts

1. Black-Phosphate Steel Easy-to-Install Thread-Locking Inserts. A black-phosphate finish provides mild corrosion resistance. Also known as E-Z Lok, these inserts use adhesive to keep them in place. The adhesive reaches full strength after 72 hours. Installation requires a drill bit and a standard tap. Then set the insert with a bolt and two nuts, or use an installation bit. Inserts with a thin wall are often used in small holes or near the edge of a workpiece.

Choose inserts with a thick wall for greater strength than thin-wall inserts, or to fill a large hole.

Inserts with an extra thick wall are stronger than thick- and thin-wall inserts. Use them to reduce the size of tapped holes.

To drive slotted inserts, you can use a slotted screwdriver instead of using an installation bit or a bolt and two nuts.

2.18-8 Stainless Steel Easy-to-Install Thread-Locking Inserts.

Made of 18-8 stainless steel, these inserts have good corrosion resistance. Also known as E-Z Lok, they use adhesive to keep them in place. The adhesive reaches full strength after 72 hours. They may be mildly magnetic. Installation requires a drill bit and a standard tap. Then set the insert with an installation bit, a slotted screwdriver, or a bolt with two nuts.

Inserts with a thin wall are often used in small holes or near the edge of a workpiece.

Choose inserts with a thick wall for greater strength than thin-wall inserts, or to fill a large hole.

Inserts with an extra thick wall are stronger than thick- and thin-wall inserts. Use them to reduce the size of tapped holes.

3.316 Stainless Steel Easy-to-Install Thread-Locking Inserts

These inserts are the most corrosion-resistant thread-locking inserts we offer. Also known as E-Z Lok, they use adhesive to keep them in place. The adhesive reaches full strength after 72 hours. All have thick walls for strength and can be used to fill a large hole with stripped threads. They may be mildly magnetic. Installation requires a drill bit and a standard tap. Then set the insert with an installation bit, a slotted screwdriver, or a bolt with two nuts.

When a small number of installations is available, a simple installation method can be adopted, which is to adopt the bolt and nut with the corresponding specifications, fix the self-attack screw sleeve on the corresponding type screw, and use the same type of nut to fix it, so that the three will become a whole. The handlebar sleeve is screwed into the screw hole, then exit. The batch installation of self-tapping inserts (threaded sleeve) can be made by special screw installation tools. The operator can't get the right picture at the end of the operation. The end of the tool is a four-sided square handle, which can be installed by manual wrench, and can also be equipped with electric tools or pneumatic tools.

Self-tapping inserts (screw sets) installation precautions:

1. For different processing materials, refer to the drill size specification for pre-drilling. When the corresponding material hardness is high, please increase the bottom hole slightly.

2. The self-tapping screw set of screwing tools front screw head, a screw slot end down, please confirm when the load vertical alignment base hole, a screw must not tilt, install the base hole of a screw also can guide 2-3 laps, installation guide, Avoid installation of swirls.

Size Can also be According to the Customer's requirement and please check the detailed specification sheet details PDF, CAD, 87-88Page See more product details.

The inner packaging is a plastic bag, and the outer packaging is a carton. Then the tray. Carton size: 29*19*19.5CM and 23.5*17.5*8, CM and pallet size: 215*100*90CM, or as your request