JX-21JG453-D9-71.2-B, CNC brass machining precision medical equipment parts, application diagnostic equipment category, treatment equipment category, and auxiliary equipment category. Diagnostic equipment category can be divided into eight categories: X-r

Copper chromium plating is a layer of chromium plated on the surface of copper products. The chrome plating layer has high hardness, depending on the composition of the plating solution and process conditions, its hardness can vary in a wide range of 400 ~ 1200 HV. The chromium plating layer has good heat resistance, and its gloss and hardness do not change significantly when heated below 500°C. The temperature is greater than 500°C and starts to oxidize and discolor, and the hardness starts to decrease above 700°C. The friction coefficient of the chrome-plated layer is small, especially the dry friction coefficient, which is the lowest among all the metals.

Hard chrome plating, opal chrome plating, loose hole chrome plating, and black chrome plating are mainly used in industry to improve the hardness, wear resistance, corrosion resistance, etc. of mechanical parts. Chrome plating is commonly used for the protection and decoration of parts of automobiles, bicycles, sewing machines, clocks and watches, instruments and meters, lamps and lanterns, daily-use hardware, etc.

Copper precision turned parts. Juxin is good at turning all kinds of copper parts, all kinds of valve parts, electrical parts, copper nuts, cell phone antennas, knurling (straight/bevel/mesh), and so on.

The picture on the left shows a turned copper core for valves, made of C3604 fast-cutting steel brass, custom-made copper turned parts for valve stems and cores according to customer requirements. Automatic turning, head milling, and stem milling at an angle of 60 degrees. This copper precision-turned part is applied to the forming tool many times. Juxin can provide brass turning parts in the following materials: C3604 series brass (including lead-free copper), H59, H60, H62, and other series of national standard brass, TU1 oxygen-free copper, purple copper, etc.

Packing: Inner is Poly foam, out is carton. Then pallet. Carton size: 29*19*19.5CM and 23.5*17.5*8, CM and pallet size is: 215*100*90CM, or as your requirement.

Packing for CNC Brass parts:

1. Usual packing: By pearl cotton/bubble bag/plastic wrap + carton box, 0.5-10kg/carton box.

2. Special packing(for large part/large quantity order): By pearl cotton/bubble bag/plastic wrap +carton box+wooden box.

3. As customers' requirement for CNC aluminum parts