JX-21JG407-D13.9-21.3-AL, Aluminum machined parts, audio equipment manufacturing switches, surface treatment anodizing related

Process characteristics of aluminum parts processing:

(1) can reduce the influence of residual stress on processing deformation. After the completion of rough machining, it is recommended to use heat treatment to remove the stress generated by the rough machining of the part to reduce the impact of stress on the quality of finishing.

(2) Improve machining accuracy and surface quality. After the separation of roughing and finishing, finishing is just a small machining allowance, machining stress, and deformation is small, which can greatly improve the quality of the parts.

(3) Improve production efficiency. Because rough machining only removes excess material, leaving enough margin for finishing, so do not consider the size and tolerance, effectively plays the performance of different models of machine tools to improve cutting efficiency.

After the aluminum parts are cut, the metal organization in the machining table will be greatly changed. In addition, the effect of cutting motion can lead to greater residual stresses. In order to reduce the deformation of the part, the residual stresses in the material need to be fully released.

6061-T6 series is an aluminum, magnesium, and silicon alloy, which is a heat treatment type corrosion-resistant alloy. The strength and corrosion resistance are very good, and the uniformity is good. Basic introduction 6061 T6 high strength, high hardness (up to HV90 degrees or more), good processing effect, good oxidation effect. No trachoma, good flatness. Improve processing efficiency and reduce material cost.

Packing: Inner is Poly foam, out is carton. Then pallet. Carton size: 29*19*19.5CM and 23.5*17.5*8, CM and pallet size is: 215*100*90CM, or as your requirement.

Packing for CNC aluminum parts:

1. Usual packing: By pearl cotton/bubble bag/plastic wrap + carton box, 0.5-10kg/carton box.

2. Special packing(for large part/large quantity order): By pearl cotton/bubble bag/plastic wrap +carton box+wooden box.

3. As customers' requirement for CNC aluminum parts