JX-21QJG277-D9.5-35.1-SS, Stainless steel Automotive wiper rivets

The rivet of the wiper should be the rivet on the top of the wiper. It can be seen from the cab at the link between the swing arm of the wiper and the wiper. When removing the rivets of the wiper, be sure to use professional tools, preferably with a piece of cotton cloth, so as to avoid scratching the wiper. The rivet of the wiper should be the rivet on the top of the wiper. It can be seen from the cab at the link between the swing arm of the wiper and the wiper. When removing the rivets of the wiper, be sure to use professional tools, preferably with a piece of cotton cloth, so as to avoid scratching the wiper.

Technical requirements: 

1. The surface of the part is smooth and flat, without flash or burr

2. Surface treatment: After 96 hours of neutral fog test, there is no red and black rust after the treatment is completed. Dimensions meet the requirements of the drawings

3. Mark * is the key Kontron dimension without chamfering, press C03

Stainless Steel General Characteristics: Designed for machining, non-magnetic

Common Applications: Electronic hardware, automotive, aerospace, medical instruments, and many applications requiring corrosion resistance

Tolerances for 1/2" Dia: Cold finished+/- .002.Passivation treatment of stainless steel fasteners

1. Degreasing and degreasing: Clean the whole workpiece with KM0109 stainless steel cleaner (time is 1 minute) until the surface is completely free of oil, rust stains, and other impurities.

2. Passivation: Immerse the workpiece in stainless steel passivation solution ID3000-1 for 30 minutes, the original solution can be immersed. After the passivation time, directly remove the workpiece and rinse clean with cleaning.

3. Closure: 15 minutes, the workpiece will be immersed in stainless steel sealer KM0421, room temperature operation, the original liquid soaking can be. Time to, remove the workpiece with cleaning rinse clean.

4. Over pure water: the workpiece will be immersed in pure water, the time is 5-10 minutes, with filtered water or barrels of pure water can be soaked at room temperature.

5. Drying and packing.

●The workpiece must be cleaned before entering the passivation solution. If the workpiece is rusted or has polishing wax before passivation, the rust or wax must be removed first.

●The workpiece must be rinsed clean before any process, and there must be no residue of the chemical solution from the previous process on the surface.

●The workpiece should be as dry as possible before entering the passivation solution to avoid excessive moisture entrained on the workpiece to dilute the passivation solution.

For small precision parts, shake or stir the workpiece at intervals of 5-10 minutes during the passivation and sealing process (do not use sharp stirring instruments to avoid scratching the workpiece) so that the solution and the workpiece can be in full contact.

Packing: Inner is Poly foam, out is carton. Then pallet. Carton size: 29*19*19.5CM and 23.5*17.5*8, CM and pallet size is: 215*100*90CM, or as your requirement.

Packaging & Delivery and Packaging Details

1. Shrink film+wooden box

2. Cardboard box+pallet

3. Color box

4. As per the customer's request